Systems · 04
Detection and alarm
The system that buys time. Detecting ten minutes earlier completely changes the outcome of a fire.
We install detection and alarm systems under NFPA 72: conventional or addressable control panels, smoke, heat and beam detectors, manual pull stations, horns, strobes and monitoring and interface modules.
The system integrates with everything else: sprinkler valve supervision, fire pump start signals, HVAC shutdown, door release and special suppression activation. A panel that only makes noise uses a fraction of what it can do.
We hand over the cause-and-effect matrix documented and tested point by point — not just a panel showing green.
Where it applies
- Corporate buildings, offices and workspaces
- Shopping centers, hotels and hospitals
- Industrial plants and process areas
- Server rooms and technical spaces
- Residential towers and mixed-use buildings
Other systems
Automatic sprinklers
Wet, dry, preaction and deluge systems under NFPA 13, with calculated density.
02Hydrants and hose cabinets
Exterior hydrants, fire department connections and equipped cabinets under NFPA 14 and 24.
03Piping networks and fire pump rooms
Tank, main pump, jockey pump and listed controller sized under NFPA 20.
05Special hazard suppression
Clean agents, foam and kitchen systems for hazards where water is not the answer.
06Extinguishers and signage
Selection, placement, recharge and signage under NFPA 10 and NOM-002-STPS.
Next step
Have a project, a pending inspection, or a system that no longer complies?
Tell us what the building is and what stage you are in. If we can solve it, we will tell you the scope and investment range. If we cannot, we will tell you that too.